how to reset the tire pressure light on my Toyota Highlander Fourth Generation (2020-present)

Toyota Highlander Fourth Generation (2020-present)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

427 words

Problem Statement

Learn how to reset the tire pressure light on your Toyota Highlander (2020-present). Step-by-step guide with diagnostic steps and tools required.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

1
Check all tire pressures using a reliable tire pressure gauge.
2
Inflate or deflate tires to the manufacturer-recommended pressure.
3
Turn the ignition to the 'ON' position without starting the engine.
4
Locate the TPMS reset button (usually beneath the steering wheel or on the dashboard).
5
Press and hold the TPMS reset button until the tire pressure light blinks three times, then release.
6
Start the vehicle and let it run for a few minutes to confirm the reset.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check all tire pressures using a reliable tire pressure gauge.
2
Inflate or deflate tires to the manufacturer-recommended pressure.
3
Turn the ignition to the 'ON' position without starting the engine.
4
Locate the TPMS reset button (usually beneath the steering wheel or on the dashboard).
5
Press and hold the TPMS reset button until the tire pressure light blinks three times, then release.
6
Start the vehicle and let it run for a few minutes to confirm the reset.

Solution

1. Preparation

Gather necessary tools: tire pressure gauge, air compressor (if needed), and TPMS reset button information.
Ensure all tires are at the recommended pressure as per the vehicle’s owner manual.

2. Resetting the TPMS

Turn Ignition On
- Insert the key and turn it to the "ON" position without starting the engine.
Locate the TPMS Reset Button
- Find the TPMS reset button, typically located under the dashboard or near the steering wheel.
Press and Hold the TPMS Reset Button
- Press and hold the button until the tire pressure light blinks three times, then release it.
Start the Vehicle
- Turn the ignition to the "START" position to start the vehicle.
Allow the System to Reset
- Drive the vehicle for about 10 minutes to allow the TPMS to complete the reset process.