how to replace cabin air filter in Toyota Highlander XU70 (2020-Present)

Solution

1. Preparation

• Tools Required:

  • Phillips screwdriver
  • Flathead screwdriver (optional)

• Sub-steps:

  1. Park the vehicle on a flat surface and turn off the ignition.
  2. Disconnect the negative battery terminal to prevent any electrical issues.
  3. Gather tools and new cabin air filter.

2. Remove Glove Compartment

• Sub-steps:
  1. Locate the stops on either side of the glove compartment and gently push them inward to release the compartment.
  2. Swing the glove compartment down to gain access to the cabin air filter area.

3. Access Cabin Air Filter

• Sub-steps:
  1. Remove the screws securing the cabin air filter access cover using a Phillips screwdriver.
  2. Carefully pull off the access cover to expose the cabin air filter.

4. Replace Cabin Air Filter

• Sub-steps:
  1. Slide the old cabin air filter out of its housing, noting the orientation of the filter.
  2. Install the new cabin air filter in the same orientation as the old one (usually indicated by airflow arrows on the filter).
  3. Ensure a snug fit of the new filter in the housing.

5. Reassemble Components

• Sub-steps:
  1. Reattach the cabin air filter access cover and secure it with screws.
  2. Lift the glove compartment back into position and push the stops back into place.
  3. Reconnect the negative battery terminal.

6. Test the System

• Sub-steps:
  1. Start the vehicle and turn on the HVAC system to check for proper airflow.
  2. Ensure there are no unusual noises and that airflow is improved.