how to reset the maintenance light on my Toyota Highlander XU70 (2020-Present)?

Toyota Highlander XU70 (2020-Present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

416 words

Problem Statement

Learn how to reset the maintenance light on your 2020-present Toyota Highlander XU70. Step-by-step guide to ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe location with the engine off while performing the reset.

Symptoms

•Maintenance light remains illuminated on the dashboard
•Reminder for maintenance appears on the display
•Engine oil change interval message is displayed
•Vehicle may prompt for service at startup

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and all doors are closed.
2
Press and hold the odometer reset button on the instrument cluster.
3
Turn the ignition key to the 'ON' position without starting the engine.
4
Continue holding the odometer reset button until the maintenance light flashes and then turns off.
5
Release the odometer reset button.
6
Turn the ignition back to the 'OFF' position and then start the engine to verify the light is reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•No special tools required.

Parts Required

•No parts required for this procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and all doors are closed.
2
Press and hold the odometer reset button on the instrument cluster.
3
Turn the ignition key to the 'ON' position without starting the engine.
4
Continue holding the odometer reset button until the maintenance light flashes and then turns off.
5
Release the odometer reset button.
6
Turn the ignition back to the 'OFF' position and then start the engine to verify the light is reset.

Solution

1. Preparation

Gather necessary tools: No special tools are required for this procedure.
Ensure vehicle is parked on a level surface and the engine is off.

2. Resetting the Maintenance Light

Close All Doors: Ensure all doors are fully closed to prevent any interruptions.
Press Odometer Reset Button: Locate the odometer reset button on the instrument cluster and press it.
Turn Ignition to ON: Without starting the engine, turn the ignition key to the "ON" position. This is the position just before starting the engine.
Hold the Button: Continue to hold the odometer reset button for approximately 10 seconds. Watch for the maintenance light to flash.
Release Button: Once the maintenance light turns off, release the odometer reset button.
Verify Reset: Turn the ignition back to the "OFF" position and then start the engine to confirm that the maintenance light has been reset.