how to fix P0011 code in Toyota RAV4 Fifth Generation (2019-present)

Solution

1. Preparation

• Gather tools and parts required for the repair.
• Disconnect the negative battery terminal.
• Ensure the engine is cool before beginning work.

2. Replace VVT Solenoid

1. Locate the VVT Solenoid:
   • Refer to the service manual for the specific location of the VVT solenoid on the engine.
2. Remove the Electrical Connector:
   • Gently unplug the electrical connector from the VVT solenoid.
3. Remove the Solenoid:
   • Use a socket set to remove the bolts securing the VVT solenoid to the engine.
   • Carefully lift the solenoid out of its mounting position.
4. Install New VVT Solenoid:
   • Position the new solenoid in place and secure it with the bolts. Torque to manufacturer specifications.
5. Reconnect the Electrical Connector:
   • Plug the electrical connector back into the new VVT solenoid.

3. Check Engine Oil Level

1. Check Oil Level:
   • Remove the dipstick, clean it, and reinsert it to check the oil level.
2. Add Oil if Necessary:
   • If low, add the correct type and amount of engine oil as specified by Toyota.

4. Clear Codes and Test

1. Clear the Error Codes:
   • Use the OBD-II scanner to clear the P0011 code from the ECM.
2. Reconnect the Battery:
   • Reattach the negative battery terminal.
3. Start the Engine:
   • Start the engine and let it idle for a few minutes.
4. Test Drive:
   • Drive the vehicle under various conditions to ensure the check engine light does not illuminate again.