how to reset the maintenance light on my Toyota RAV4 Fifth Generation (2019-present)

Toyota RAV4 Fifth Generation (2019-present)

Error Codes

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

386 words

Problem Statement

Learn how to reset the maintenance light on your Toyota RAV4 (2019-present) with this easy step-by-step guide. Ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

5 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral and on a flat surface before performing the reset.

Symptoms

•Maintenance light is illuminated on the dashboard
•No other warning lights are present
•Vehicle has undergone scheduled maintenance

Diagnostic Steps

1
Turn the ignition switch to the 'OFF' position.
2
Press and hold the trip meter reset button on the instrument panel.
3
While holding the reset button, turn the ignition switch to the 'ON' position (do not start the engine).
4
Continue to hold the reset button until the maintenance light flashes and then turns off.
5
Release the trip meter reset button.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•No special tools are required.

Parts Required

•No parts are required for resetting the maintenance light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the 'OFF' position.
2
Press and hold the trip meter reset button on the instrument panel.
3
While holding the reset button, turn the ignition switch to the 'ON' position (do not start the engine).
4
Continue to hold the reset button until the maintenance light flashes and then turns off.
5
Release the trip meter reset button.

Solution

1. Preparation

Ensure the vehicle is in a safe location with the ignition off.
Gather necessary tools (if required).

2. Resetting the Maintenance Light

Turn Off the Ignition:
- Ensure the vehicle's ignition is completely off.
Press and Hold the Trip Meter Reset Button:
- Locate the trip meter reset button on the instrument panel.
- Press and hold this button.
Turn the Ignition On:
- While continuing to hold the trip meter reset button, turn the ignition key to the "ON" position without starting the engine.
Wait for the Light to Reset:
- Keep holding the button until the maintenance light begins to flash and then turns off.
- This usually takes about 10-15 seconds.
Release the Trip Meter Reset Button:
- Once the maintenance light is off, release the button.

3. Confirm the Reset

Turn the ignition off and then back on to ensure the maintenance light remains off.