how to reset the maintenance light on Toyota RAV4 Fifth Generation (2019-present)

Toyota RAV4 Fifth Generation (2019-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

332 words

Problem Statement

Learn how to reset the maintenance light on your 2019-2023 Toyota RAV4. Step-by-step guide to clear the reminder after maintenance.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe, stationary position before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Notification of upcoming service in the vehicle's information display
•No engine performance issues related to the reset procedure

Diagnostic Steps

1
Ensure the vehicle is parked and the engine is turned off.
2
Insert the key into the ignition or press the start button without pressing the brake pedal to enter the accessory mode.
3
Confirm that the odometer display is showing the total miles (not trip A or trip B).
4
Press the gas pedal three times within five seconds to initiate the reset sequence.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is parked and the engine is turned off.
2
Insert the key into the ignition or press the start button without pressing the brake pedal to enter the accessory mode.
3
Confirm that the odometer display is showing the total miles (not trip A or trip B).
4
Press the gas pedal three times within five seconds to initiate the reset sequence.

Solution

1. Preparation

Gather necessary tools: none required for this procedure.
Ensure all doors are closed and the vehicle is in a safe location.

2. Enter Maintenance Reset Mode

Ignition Position: Turn the key to the "On" position or press the start button without engaging the brake pedal.
Odometer Check: Verify the odometer is displaying total miles.
Gas Pedal Action: Quickly press the gas pedal three times within five seconds.

3. Complete the Reset

Observe the maintenance light: It should flash and then turn off if the reset is successful.
Turn off the ignition to exit the maintenance mode once the light is off.