how to solve oil consumption issues in Toyota RAV4 Fifth Generation (2019-present)

Solution

1. Preparation

• Gather necessary tools and parts.
• Ensure the vehicle is parked on a level surface and the engine is cool.
• Disconnect the battery to prevent electrical shorts.

2. Inspect and Replace PCV Valve

• Tools Required: Socket set, pliers, new PCV valve
• Remove the engine cover if applicable.
• Locate the PCV valve on the valve cover.
• Disconnect the hoses leading to the PCV valve.
• Remove the old PCV valve by twisting it and pulling it out.
• Insert the new PCV valve into the valve cover until it clicks into place.
• Reconnect the hoses securely.

3. Perform an Engine Oil Change

• Tools Required: Oil filter wrench, oil catch pan, funnel, socket set
• Remove the oil drain plug and allow the old oil to drain completely into the catch pan.
• Replace the oil drain plug and torque it to the manufacturer's specifications (typically around 30 lb-ft).
• Remove the old oil filter using the oil filter wrench.
• Lubricate the rubber gasket of the new oil filter with a little new oil and install it.
• Fill the engine with the correct type and amount of oil (usually 0W-20 for RAV4) using a funnel.
• Start the engine and allow it to run for a few minutes, then check for leaks.

4. Monitor and Test

• After completing the oil change and PCV valve replacement, drive the vehicle for a short distance.
• Check the oil level again after a short drive and add oil if necessary.
• Monitor oil consumption over the next few weeks.