how to fix P0011 timing issue in my Toyota RAV4 XA50 (2019-2024)

Solution

1. Preparation

• Gather tools and parts required for the repair.
• Disconnect the negative battery terminal to prevent electrical shock.
• Allow the engine to cool before starting work.

2. Change Engine Oil and Filter

1. Drain Oil:
   • Place a drain pan under the oil pan, remove the drain plug, and allow oil to completely drain.
   • Torque the drain plug to manufacturer specifications (typically around 25-30 ft-lbs).
2. Replace Oil Filter:
   • Remove the old oil filter using an oil filter wrench.
   • Lubricate the rubber gasket of the new filter with clean oil and install it hand-tight.
3. Refill Engine Oil:
   • Replace the drain plug if it was removed.
   • Fill the engine with the correct type and quantity of oil (typically 0W-20 for the RAV4).
   • Start the engine and allow it to run for a minute, then check the oil level and add if necessary.

3. Inspect and Replace VVT Solenoid

1. Locate the VVT Solenoid:
   • Remove any engine covers as necessary to access the VVT solenoid.
2. Disconnect Electrical Connector:
   • Unplug the electrical connector from the solenoid.
3. Remove the VVT Solenoid:
   • Remove the bolts securing the solenoid using a socket wrench.
   • Carefully pull the solenoid out of its mounting position.
4. Install New VVT Solenoid:
   • Position the new solenoid in place and tighten the bolts to manufacturer specifications (typically around 8-10 ft-lbs).
   • Reconnect the electrical connector.

4. Reset ECM

1. Reconnect Battery:
   • Reconnect the negative battery terminal.
2. Clear Codes:
   • Use the OBD-II scanner to clear the P0011 code and any other related codes.