how to reset maintenance light on Toyota RAV4 XA50 (2019-2024)

Toyota RAV4 XA50 (2019-2024)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

428 words

Problem Statement

Learn how to reset the maintenance light on your Toyota RAV4 XA50 (2019-2024) with this simple step-by-step guide. Quick and easy procedure.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park (or neutral for manual transmissions) to prevent movement during the reset process.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder message displayed on the multi-information display
•Engine oil change or service due notification active

Diagnostic Steps

1
Turn the vehicle ignition to the 'ON' position without starting the engine.
2
Locate the trip meter reset button on the dashboard.
3
Press and hold the trip meter reset button until the trip meter reads '0.0' miles.
4
While holding the trip meter reset button, turn the ignition switch OFF and then back to the 'ON' position.
5
Continue to hold the trip meter reset button until the maintenance light blinks and then turns off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for this reset procedure.

Parts Required

•None required.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the vehicle ignition to the 'ON' position without starting the engine.
2
Locate the trip meter reset button on the dashboard.
3
Press and hold the trip meter reset button until the trip meter reads '0.0' miles.
4
While holding the trip meter reset button, turn the ignition switch OFF and then back to the 'ON' position.
5
Continue to hold the trip meter reset button until the maintenance light blinks and then turns off.

Solution

1. Preparation

Ensure the vehicle is parked safely with the ignition off.
Gather necessary tools: none required for this procedure.

2. Turn Ignition to ON

Insert the key or press the start button to set the ignition to the "ON" position.
Do not start the engine; just power the electrical systems.

3. Reset Trip Meter

Locate the trip meter reset button on the instrument panel.
Press and hold the trip meter reset button.
Keep holding the button until the trip meter displays "0.0".

4. Turn Ignition OFF and ON

While still holding the trip meter reset button, turn the ignition key to the "OFF" position.
Then, turn the ignition back to the "ON" position without starting the engine.

5. Release Button and Confirm Reset

Continue holding the trip meter reset button for approximately 10 seconds.
Watch for the maintenance light to blink and then turn off, indicating a successful reset.
Release the trip meter reset button.