how to reset the tire pressure light on Toyota Tacoma N300 (2016-Present)

Toyota Tacoma N300 (2016-Present)

30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

470 words

Problem Statement

Learn how to reset the tire pressure light on your 2016-present Toyota Tacoma N300. Step-by-step guide with diagnostic procedures and tips.

Affected Component

Electrical

Estimated Time

30 minutes

Important safety information - read before proceeding

•Always ensure that tires are at the correct pressure before performing the reset to avoid driving on under-inflated tires.

1
Check the tire pressures of all tires using a tire pressure gauge to ensure they meet the manufacturer’s specifications.
2
Inspect tires for damage or leaks that may affect pressure.
3
If necessary, inflate any under-inflated tires to the recommended pressure.
4
Verify that the spare tire (if equipped with a TPMS sensor) is also at the correct pressure.
5
If pressures are correct and the light remains on, prepare to reset the TPMS.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

•None for the reset process; however, ensure all tires are in good condition and properly inflated.

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check the tire pressures of all tires using a tire pressure gauge to ensure they meet the manufacturer’s specifications.
2
Inspect tires for damage or leaks that may affect pressure.
3
If necessary, inflate any under-inflated tires to the recommended pressure.
4
Verify that the spare tire (if equipped with a TPMS sensor) is also at the correct pressure.
5
If pressures are correct and the light remains on, prepare to reset the TPMS.

Solution

1. Preparation

2. Reset the TPMS

Locate the TPMS Reset Button:
- The reset button is usually found beneath the steering column or near the fuse box. Refer to the owner's manual for the exact location.
Turn On the Ignition:
- Insert the key and turn the ignition to the "ON" position without starting the engine. If equipped with a push-button start, press the button twice without pressing the brake pedal.
Press and Hold the Reset Button:
- Press and hold the TPMS reset button until the tire pressure light blinks three times, then release the button.
Start the Engine:
- Start the vehicle and allow it to run for about 20 minutes to permit the TPMS to recalibrate.
Verify the Light Status:
- After driving, check if the tire pressure light has turned off. If it remains illuminated, repeat the reset process or check for additional issues.