how to reset the oil light in my Volkswagen Golf Seventh Generation (2013-2020)

Volkswagen Golf Eighth Generation (2020-present)

Error Codes

Less than 15 minutes

Time

easy

Difficulty

low

Severity

2 min read

356 words

Problem Statement

Learn how to reset the oil light in your Volkswagen Golf (2013-2020) with this simple step-by-step guide. Quick and easy instructions for maintenance.

Affected Component

Engine

Estimated Time

Less than 15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' and on a flat surface before performing the reset.

Symptoms

•Oil change light illuminated on the dashboard
•Maintenance reminder message displayed
•Engine oil replaced recently

Diagnostic Steps

1
Ensure the vehicle is in the 'Off' position.
2
Insert the key into the ignition without starting the engine.
3
Press the accelerator pedal three times within 10 seconds.
4
Turn the ignition to the 'On' position (do not start the engine).
5
Observe if the oil change light resets.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key or key fob

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools:
- Vehicle key or key fob
Ensure the vehicle is parked on a flat surface with the engine off.

2. Ignition Sequence

Insert the key into the ignition or press the start button without pressing the brake pedal to enter the accessory mode.
Confirm that the dashboard lights illuminate without starting the engine.

3. Reset Procedure

Accelerator Pedal Action:
- Fully depress the accelerator pedal three times in quick succession. Make sure to do this within a span of 10 seconds.
Turn Ignition On:
- After the accelerator pedal action, turn the ignition key to the "On" position, but do not start the engine.
Check for Reset:
- Look at the dashboard display to see if the oil change light has turned off. If it remains illuminated, repeat the process.