why does my Volkswagen Golf MK7.5 (2020-Present) engine sound loud when accelerating?

Volkswagen Golf MK7.5 (2020-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

461 words

Problem Statement

Learn how to diagnose and fix loud engine noise during acceleration in Volkswagen Golf MK7.5. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Exhaust System

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before inspecting the exhaust system.

Symptoms

•Increased engine noise during acceleration
•Possible vibrations felt in the cabin
•Reduced engine performance or responsiveness
•Check engine light illuminated (if applicable)
•Unusual exhaust odor (if exhaust leak is present)

Diagnostic Steps

1
Inspect the exhaust system for visible leaks or damage.
2
Use an OBD-II scanner to check for any stored trouble codes.
3
Listen for abnormal sounds while revving the engine in neutral.
4
Check engine mounts for wear or damage that could cause excessive engine noise.
5
Examine the air intake system for any obstructions or leaks.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Torque wrench
•Jack and jack stands
•Exhaust sealant

Parts Required

•Exhaust sections (if damaged)
•Engine mounts (if worn)
•Air filter (if dirty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the exhaust system for visible leaks or damage.
2
Use an OBD-II scanner to check for any stored trouble codes.
3
Listen for abnormal sounds while revving the engine in neutral.
4
Check engine mounts for wear or damage that could cause excessive engine noise.
5
Examine the air intake system for any obstructions or leaks.

Solution

1. Preparation

Gather tools and parts required for the repair.
Ensure the vehicle is parked on a flat surface and the engine is cool.
Disconnect the battery to avoid any electrical issues.

2. Inspect and Repair Exhaust System

Sub-steps:
1. Raise the vehicle using a jack and secure it with jack stands.
2. Inspect the exhaust manifold, downpipe, and muffler for cracks or holes.
3. Replace any damaged sections of the exhaust using a socket set.
4. Use exhaust sealant on joints to ensure no leaks remain.
5. Reinstall any heat shields that may have been removed.

3. Check Engine Mounts

Sub-steps:
1. Visually inspect the engine mounts for cracks or signs of excessive wear.
2. Use a torque wrench to tighten any loose bolts on the engine mounts.
3. Replace any damaged engine mounts with new ones, ensuring proper alignment.

4. Air Intake System Inspection

Sub-steps:
1. Remove the air intake duct to access the air filter and intake manifold.
2. Inspect the air filter for dirt and replace it if necessary.
3. Check for any vacuum leaks in the intake hoses and replace any damaged hoses.