my Volkswagen Tiguan makes a grinding noise when turning what's causing it

Volkswagen Tiguan Second Generation (2018-present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

556 words

Problem Statement

Learn how to diagnose and fix grinding noise when turning in Volkswagen Tiguan. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the vehicle to cool down before inspecting brake components.

Symptoms

•Grinding noise during left or right turns
•Possible vibration in the steering wheel
•Difficulty in steering or increased effort required
•Uneven tire wear
•Clunking sound when going over bumps

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any visible damage to the CV joints or boots.
3
Examine the wheel bearings for excessive play or wear.
4
Inspect the suspension components (control arms, bushings) for damage.
5
Test drive the vehicle to replicate the noise while turning.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Jack and jack stands
•CV joint puller
•Bearing puller
•Torque wrench

Parts Required

•CV joint
•Wheel bearings
•Control arm bushings (if applicable)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Park the vehicle on a level surface and engage the parking brake.
Disconnect the negative battery terminal for safety.

2. Inspect and Replace CV Joints

Lift the Vehicle
- Use a jack and jack stands to elevate the front of the vehicle.
- Ensure the vehicle is securely supported.
Remove Wheel
- Use a socket set to remove the lug nuts and take off the wheel.
Check CV Joint
- Inspect the CV joint for wear and the boot for tears.
- If damaged, use a CV joint puller to remove the joint from the axle shaft.
Install New CV Joint
- Grease the new CV joint and install it onto the axle shaft.
- Reattach the boot and ensure it’s properly secured.

3. Inspect and Replace Wheel Bearings

Remove Brake Caliper
- Use a socket set to remove the caliper bolts and hang it securely.
Remove Brake Rotor
- Take off the rotor for access to the wheel bearing.
Inspect Wheel Bearings
- Check for play or roughness in the bearing.
- If faulty, use a bearing puller to remove the old bearing.
Install New Wheel Bearing
- Press the new bearing into the hub using a bearing installer.
- Reassemble the rotor and caliper.

4. Inspect Suspension Components

Visual Inspection
- Check control arms and bushings for any signs of wear or damage.
Replace Damaged Components
- If any components are damaged, remove them using a socket set.
- Install new control arms or bushings as needed.

5. Reassemble and Test

Reattach the wheel and lug nuts, tightening to manufacturer specifications.
Reconnect the battery terminal.
Lower the vehicle and test drive to ensure noise is resolved.