my Volvo XC60 has a clicking noise when I turn what's causing it

Volvo XC60 First Generation (2008-2017)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

511 words

Problem Statement

Learn how to diagnose and fix a clicking noise when turning in your Volvo XC60. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always disconnect the battery before working on electrical components.
•Ensure the vehicle is securely supported on jack stands before performing any repairs.

Symptoms

•Clicking noise during turns
•Possible vibration felt in the steering wheel
•Increased resistance when turning the steering wheel
•Unusual tire wear patterns
•Greasy residue around wheel wells or CV joints

Diagnostic Steps

1
Inspect the CV joints for damage or wear.
2
Check the wheel bearings for excessive play or noise.
3
Examine the suspension components for any loose or damaged parts.
4
Verify the condition of the tires and check for uneven wear.
5
Test the steering system for any binding or unusual resistance.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•Jack and jack stands
•Bearing puller
•CV joint removal tool

Parts Required

•CV joint assembly (if worn)
•Wheel bearings (if damaged)
•Suspension components (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts before starting.
Ensure the vehicle is parked on a flat surface and securely supported with jack stands.
Disconnect the battery to prevent any electrical issues during inspection.

2. Inspect and Replace CV Joints

Sub-steps:
1. Remove the wheel by loosening the lug nuts and using a jack to lift the vehicle.
2. Inspect the CV boot for tears or grease leaks; replace if damaged.
3. If the CV joint is worn, remove the axle shaft by unbolting it from the transmission and wheel hub.
4. Replace the CV joint with a new one and ensure proper lubrication.
5. Reassemble the axle shaft, securing it with the specified torque (typically 30-50 ft-lbs).

3. Check and Replace Wheel Bearings

Sub-steps:
1. After removing the wheel, inspect the wheel bearing for play by rocking the wheel back and forth.
2. If the bearing is worn, remove the brake caliper and rotor to access the hub.
3. Use a bearing puller to remove the old bearing and install the new bearing, ensuring proper alignment.
4. Reassemble the brake components and wheel, tightening the lug nuts to the manufacturer’s specifications (typically 80-100 ft-lbs).

4. Inspect Suspension Components

Sub-steps:
1. Visually check all suspension parts, including control arms, bushings, and struts for damage or excessive wear.
2. Replace any worn or damaged suspension components.
3. Perform an alignment check after any suspension repairs to ensure proper wheel alignment.