how to fix P0011 timing issue in Volvo XC60 Second Generation (2018-2024)

Learn how to diagnose and fix P0011 timing issue in Volvo XC60. Step-by-step guide with diagnostic procedures and repair instructions.

Solution

1. Preparation

• Tools Required: OBD-II scanner, socket set, torque wrench, multimeter, oil catch pan, engine oil, VVT solenoid gasket.
• Ensure the vehicle is parked on a level surface and the engine is cool.
• Disconnect the battery to prevent any electrical short circuits.

2. Change Engine Oil

• Sub-steps:
  1. Place the oil catch pan under the oil pan.
  2. Remove the oil drain plug and allow the engine oil to drain completely.
  3. Replace the oil drain plug and tighten to manufacturer’s specifications (usually around 25 Nm).
  4. Refill with the recommended engine oil (typically 5W-30 or as specified in the owner’s manual).
  5. Start the engine and let it idle for a few minutes, then check the oil level and top off if necessary.

3. Inspect and Replace VVT Solenoid

• Sub-steps:
  1. Locate the VVT solenoid (usually found near the engine’s camshaft cover).
  2. Disconnect the electrical connector from the VVT solenoid.
  3. Remove the mounting bolts using a socket set and take out the solenoid.
  4. Clean the mounting surface on the engine.
  5. Install the new VVT solenoid with a new gasket, tightening bolts to manufacturer’s torque specifications (typically around 10 Nm).
  6. Reconnect the electrical connector.

4. Reset the Engine Control Module (ECM)

• Sub-steps:
  1. Reconnect the battery.
  2. Use the OBD-II scanner to clear the P0011 code from the ECM.
  3. Start the engine and allow it to reach operating temperature.